![]() Switch-on remote control of Sorensen power supply Switch the Remote/Local button of the Elind to Local position. Make sure both Elind potentiometers are rotated fully country-clockwise (Zero output). Select “Man” mode pressing Auto/Man button (1a). Switch-off remote control of Elind power supply ![]() Switch the Remote/Local button of the Elind to Remote position. Turn both Elind potentiometers for current and voltage output fully country-clockwise to zero the output. Set manual output limit on potentiometer 4. Select between remote control of current and voltage (switch 3, typically voltage). Select “Man” mode pressing Auto/Man button (1a) and zero output (Down button). ![]() Switch-on remote control of Elind power supply The positive (+) pole of the used N-type thermocouple (pink wire) must be connected to the shorter pin and the negative (-) (white wire) to the longer pin of the thermocouple feedthrough on the manipulator. Operation Warning! Do not connect the thermocouple input during e-beam annealing with applied high voltage.Īfter the switch-on procedure, the controller can be operated manually from the PID module by buttons 1a-e, or remotely from PC (see Software section).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |